PirelliFactory Reset ###810####520# Show Firmware VersionPolycomDefault Admin Username = PolycomDefault Admin password = 456To get into the web interface, the default username/password is "Polycom"/"456" (Note that this does not work with Safari 1.2.2.)To get into the Admin interface on the hard phone, the password is "456". (Prior to v1.3.1, the web interfaces to the phone uses "Polycom"/"SpIp" as the username/password.)The "user password" (not used much) defaults to "123". Use the admin interface via the keypad to access the reset menu and use both reset optionsSnomDefault Admin Username =Default Admin password = 0000Via HTTPEarlier than v3.0 firmware: _base_en.htm?reset=ResetV3.0 and later firmware: =ResetVia the phone keypadsnom360: Press the "Settings" Key and scroll down to "Reset Values". Confirm by pressing the tick buttonsnom320: Press the "Settings" Key and press the soft key below the displayed "Reset".snom300: Press the "Navigation Button" "down arrow" and scroll until "Configuration". Press the "Navigation Button" "right arrow" and confirm by pressing the tick button
The Inter-Asterisk eXchange (IAX) protocol is usually used for server-to-server communication; more hard phones are available that talk SIP. However,there are several soft phones that support the IAX protocol,and work is progressing on several fronts for hard phone support in firmware. The primary difference between the IAX and SIP protocols is the way media (your voice) is passed between endpoints. With SIP,the RTP (media) traffic is passed using different ports than those used by the signaling methods. For example,Asterisk receives the signaling of SIP on port 5060 and the RTP (media) traffic on ports 10,000 through 20,000, by default. The IAX protocol differs in that both the signaling and media traffic are passed via a single port: 4569. An advantage to this approach is that the IAX protocol tends to be better suited to topologies involving NAT.
Atcom At530 Firmware
DOWNLOAD: https://jinyurl.com/2vDRDx
"The Inter-Asterisk eXchange (IAX) protocol is usually used for server-to-server communication; more hard phones are available that talk SIP. However,there are several soft phones that support the IAX protocol,and work is progressing on several fronts for hard phone support in firmware. 2ff7e9595c
Comments